Author: n7ifr
Subject: Standby Monitor Question
Posted: 07 Aug 2015 at 12:27pm
Edited by n7ifr - 8 hours 32 minutes ago at 12:28pm
Subject: Standby Monitor Question
Posted: 07 Aug 2015 at 12:27pm
 DavidBunin wrote:
I think I have the levels pretty even when just one is active, because I tend to look for the little RX on the face of the IFD to tell which frequency I'm hearing. But I don't think I've tried to decide if the volume of one frequency changes when receiving a second. All of which is probably too many words to say, "I dunno." But I'm happy with it overall. David Bunin |
Thanks David.
The real issue I have with the audio volumes with the AMX240/IFD540 set from the 540, is that the volume levels are very different with and without Standby Monitoring.
After customized adjusting of the volumes for Active Comm-1 and Standby Comm-1 channels (using the 540 audio controls), deactivating the Standby "Monitor" function reverts the volume on active Comm-1 way too loud.
IOW, the 540 audio levels ought to be the same with Standby-Monitor function ON or OFF, but they are not.
Seems like the 240 Monitor switch is introducing excessive attenuation onto both channels when Monitor is activated.
Tom Wolf
Edited by n7ifr - 8 hours 32 minutes ago at 12:28pm