Author: n7ifr
Subject: Standby Monitor Question
Posted: 03 Aug 2015 at 6:05pm
Just back from installer (single IFD540/AMX240), Comm-1 Standby now working.
Subject: Standby Monitor Question
Posted: 03 Aug 2015 at 6:05pm
Just back from installer (single IFD540/AMX240), Comm-1 Standby now working.
However, I am a bit disappointed: With function active (Monitor-1 button), the Comm-1 Active Volume drops very low, and Standby-1 is audible.
. Active Comm Volume adjusted by Vol Control or AUX-Audio
. Standby Comm Volume adjusted by AUX-Audio to minimum volume.
After adjusting Active Freq. Volume to be louder, and Standby Vol. lower, when resuming with Monitor button OFF the Comm-1 is way too loud, requiring turning Vol control back down.
Without "stuttering" Standby, I wonder if there a way to adjust the two volumes (Active>Standby) without requiring constant adjustment?
Does this indicate the Pin wiring is backwards?
Tom Wolf