Author: oskrypuch
Subject: Bug? Bezel display issue
Posted: 01 Feb 2015 at 2:27pm
OK, still two questions, it is just that I'm curious.
Subject: Bug? Bezel display issue
Posted: 01 Feb 2015 at 2:27pm
OK, still two questions, it is just that I'm curious.
(Q1) If the following is undesirable ...
 Note: If it is not desired to hand brightness control over to the dimming bus from the photocell at any point, set dimBus Transition % to 0 (zero). |
... what was the purpose of including that setting? Just kind of a development phase thing, that was largely orphaned, but still left in, or is there some special circumstance you might wish to use it?
(Q2) What is the purpose of treating the VOL, CDI & COM/VOR labels DIFFERENTLY from the rest of the labels? (the original question I posed, above)
*Orest